Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
crushing case necks when using expander mandrel to open case neck on a 338SS
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Mike Matteson" data-source="post: 2875994" data-attributes="member: 101791"><p>You are expanding the neck. I would use Imperial Wax instead of powder. I think I would use a brush too. A longer taper mandrel would help. I would increase the sizing in 2 steps if not 3. Go slowly, don't push it down quickly. Lube is your friend as long as you don't put to much on or in it. </p><p>Yes you have to clean your cases. That better than loosing them. Good brass is over a $1. ec now. </p><p>I am probably will have to, to get top quality brass for my 338WM rifle.</p></blockquote><p></p>
[QUOTE="Mike Matteson, post: 2875994, member: 101791"] You are expanding the neck. I would use Imperial Wax instead of powder. I think I would use a brush too. A longer taper mandrel would help. I would increase the sizing in 2 steps if not 3. Go slowly, don't push it down quickly. Lube is your friend as long as you don't put to much on or in it. Yes you have to clean your cases. That better than loosing them. Good brass is over a $1. ec now. I am probably will have to, to get top quality brass for my 338WM rifle. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
crushing case necks when using expander mandrel to open case neck on a 338SS
Top