Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Critique my Threading and Chambering - Video
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="ThrdKllr" data-source="post: 1872045" data-attributes="member: 110734"><p>There's no reason to use a floating reamer holder for the counter bore reaming tool. With it held rigidly, even if it is off.010 it will just make the counter bore .020 bigger in diameter since the barrel is rotating. I drive my reamer with a live center in the tailstock but I make sure my tailstock is perfectly aligned. Lots of ways to skin a cat without getting hair on the meat.</p></blockquote><p></p>
[QUOTE="ThrdKllr, post: 1872045, member: 110734"] There’s no reason to use a floating reamer holder for the counter bore reaming tool. With it held rigidly, even if it is off.010 it will just make the counter bore .020 bigger in diameter since the barrel is rotating. I drive my reamer with a live center in the tailstock but I make sure my tailstock is perfectly aligned. Lots of ways to skin a cat without getting hair on the meat. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Critique my Threading and Chambering - Video
Top