Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Case too tight
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="mike33" data-source="post: 387157" data-attributes="member: 14195"><p>Im having the same trouble with my new wildcat 25 WSM using the 270 wsm necked to 25. I dont want to oversize and throw off the head space. My big problem is if i go a little farther than shell holder i start crushing the case at the shoulkder and case wall jucntion. But my real problem has been working up loads my best vel. and accuracy 1/2 moa and 3650 vel. with 100 grain sierra bt is extrtaction. Case sticks in chamber and extractor wont pull it out. Bolt lifts good and comes back but case stays in chamber and have to use a cleaning rod to remove. I know everyone is going to say load is to hot but i only have aslight plunger mark on case. I have done this hundreds of times and never had this problem from pressure. I wondering if my extractor is bad it is factory remington . Also the fired case is stiff to reclose bolt and still wont extract after being placed back in after fired. I shot this load on sat. temp. 81 degree no problem today had this problem with 72 degree temp with humidity from on and off rain showers. Im using new redding dies, and rockchucker press. Any help would be appreciated.</p><p>Mike</p></blockquote><p></p>
[QUOTE="mike33, post: 387157, member: 14195"] Im having the same trouble with my new wildcat 25 WSM using the 270 wsm necked to 25. I dont want to oversize and throw off the head space. My big problem is if i go a little farther than shell holder i start crushing the case at the shoulkder and case wall jucntion. But my real problem has been working up loads my best vel. and accuracy 1/2 moa and 3650 vel. with 100 grain sierra bt is extrtaction. Case sticks in chamber and extractor wont pull it out. Bolt lifts good and comes back but case stays in chamber and have to use a cleaning rod to remove. I know everyone is going to say load is to hot but i only have aslight plunger mark on case. I have done this hundreds of times and never had this problem from pressure. I wondering if my extractor is bad it is factory remington . Also the fired case is stiff to reclose bolt and still wont extract after being placed back in after fired. I shot this load on sat. temp. 81 degree no problem today had this problem with 72 degree temp with humidity from on and off rain showers. Im using new redding dies, and rockchucker press. Any help would be appreciated. Mike [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Case too tight
Top