Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Can't tap out Rem 700 trigger pins! Ahhgg!
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="J E Custom" data-source="post: 299739" data-attributes="member: 2736"><p>Some are harder than others and if they have been driven out the wrong way they get </p><p>tough.</p><p></p><p>Always drive them out from the safety side . Normally if you look close one end of the pin</p><p>has a little chamfer on it and that is the it was installed (the chamfer makes it easier to</p><p>start .</p><p></p><p>These pins are not tapered but sometimes get ruff treatment from the factory and peen</p><p>the end over a little making them hard to remove.</p><p></p><p>J E CUSTOM</p></blockquote><p></p>
[QUOTE="J E Custom, post: 299739, member: 2736"] Some are harder than others and if they have been driven out the wrong way they get tough. Always drive them out from the safety side . Normally if you look close one end of the pin has a little chamfer on it and that is the it was installed (the chamfer makes it easier to start . These pins are not tapered but sometimes get ruff treatment from the factory and peen the end over a little making them hard to remove. J E CUSTOM [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Can't tap out Rem 700 trigger pins! Ahhgg!
Top