Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Can't get the barrel off my M700. Help!
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="westcliffe01" data-source="post: 780105" data-attributes="member: 35183"><p>Whats an M700 ? The NSS receiver wrench uses a bolt into the forward action screw hole to 100% absolutely prevent any movement of the wrench on the action. For the barrel, if it tapers, you need barrel blocks with a matching tapered hole ! The set I got for assembling my FN FAL is made like that. You put the aluminum block on the small end of the barrel and slide it rearward until the tapers match, then you line up the second one and clamp them up. Rosin is used between plates and barrel to prevent slippage.</p><p></p><p>It sounds like you don't have the right tools for the job.</p><p></p><p>Read this page <a href="http://www.faltools.com/?page_id=50" target="_blank">Barrel Vise Use</a></p><p></p><p>If you call him up, I am pretty sure he can custom make you a pair of blocks for your specific barrel diameter/taper.</p></blockquote><p></p>
[QUOTE="westcliffe01, post: 780105, member: 35183"] Whats an M700 ? The NSS receiver wrench uses a bolt into the forward action screw hole to 100% absolutely prevent any movement of the wrench on the action. For the barrel, if it tapers, you need barrel blocks with a matching tapered hole ! The set I got for assembling my FN FAL is made like that. You put the aluminum block on the small end of the barrel and slide it rearward until the tapers match, then you line up the second one and clamp them up. Rosin is used between plates and barrel to prevent slippage. It sounds like you don't have the right tools for the job. Read this page [url=http://www.faltools.com/?page_id=50]Barrel Vise Use[/url] If you call him up, I am pretty sure he can custom make you a pair of blocks for your specific barrel diameter/taper. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Can't get the barrel off my M700. Help!
Top