Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Bumped Shoulders too much
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Mikecr" data-source="post: 1314062" data-attributes="member: 1521"><p>IMO, a lesson to take from this is always verify what you're doing -while doing so (instead of finding out a harder way).</p><p></p><p>Every chamber, brass, case holder, press, and die are different,, even the lube type and amount vary results, so there is no rule of thumb that credibly applies for proper bumping. You creep into it, and verify it is correct, for every single case. Just get used to this, and it's no big deal.</p><p>Same with powder charging, primer seating, bullet seating, neck turning, etc..</p></blockquote><p></p>
[QUOTE="Mikecr, post: 1314062, member: 1521"] IMO, a lesson to take from this is always verify what you're doing -while doing so (instead of finding out a harder way). Every chamber, brass, case holder, press, and die are different,, even the lube type and amount vary results, so there is no rule of thumb that credibly applies for proper bumping. You creep into it, and verify it is correct, for every single case. Just get used to this, and it's no big deal. Same with powder charging, primer seating, bullet seating, neck turning, etc.. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Bumped Shoulders too much
Top