Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
Bullet Bearing Surface Length Question(s)
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="royinidaho" data-source="post: 268710" data-attributes="member: 2011"><p>'nother question....</p><p></p><p>If a person was going to make their own, not that I'm going to, what would be diameter of the hole be for say the 270 cal?</p><p></p><p>I measure the hole in the "nut" thing from sinclair at 0.260". This seems to get me too far down the point/ogive and boat tail.</p><p></p><p>The bullet front end has to be deforming a bit as it grows in length when its shrunk the 0.006" from 284 to 277.</p></blockquote><p></p>
[QUOTE="royinidaho, post: 268710, member: 2011"] 'nother question.... If a person was going to make their own, not that I'm going to, what would be diameter of the hole be for say the 270 cal? I measure the hole in the "nut" thing from sinclair at 0.260". This seems to get me too far down the point/ogive and boat tail. The bullet front end has to be deforming a bit as it grows in length when its shrunk the 0.006" from 284 to 277. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
Bullet Bearing Surface Length Question(s)
Top