Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
Brass sticking at all powder charges
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="86alaskan" data-source="post: 1502357" data-attributes="member: 75933"><p>Dummy rounds can be fired and extracted normally. When fired, secondary extraction is very tight, initial bolt lift is heavier than normal but not unnecessarily so. I can cycle the handle all the way, but then the bolt is stuck to the point of having to hammer it back with a block of wood. IMR states between 88 and 96gr for 8133, I can't open the bolt at 87 or any higher. I stepped down that low to rule out brass volume and over pressure. Accuracy is high custom level across the entire ladder</p></blockquote><p></p>
[QUOTE="86alaskan, post: 1502357, member: 75933"] Dummy rounds can be fired and extracted normally. When fired, secondary extraction is very tight, initial bolt lift is heavier than normal but not unnecessarily so. I can cycle the handle all the way, but then the bolt is stuck to the point of having to hammer it back with a block of wood. IMR states between 88 and 96gr for 8133, I can't open the bolt at 87 or any higher. I stepped down that low to rule out brass volume and over pressure. Accuracy is high custom level across the entire ladder [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
Brass sticking at all powder charges
Top