Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Brass Problem
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="IceSniper" data-source="post: 103085" data-attributes="member: 2286"><p>Today i went to reload 15 rounds that i fired last night and after resizing i noticed my case trimmer wouldn't fit in the necks of 12 of them /ubbthreads/images/graemlins/confused.gif , I tryed resizing them again but it made no diffrence. Then thinking something had gone wrong with my die i cleaned it out and tryed again with no success. Finally i tryed depriming/resizing some winchester brass and my cutter fit fine. So if it's not the die or the cutter it must be the cases. But then my expander ball should pull the neck open on the up stroke regardless, yes?</p><p>I'm confused.</p><p>What could be causing this and how do i fix it? I can't give measurements because i still haven't brought a caliper /ubbthreads/images/graemlins/blush.gif .</p><p></p><p>As a side note the 3x 5-shot groups i shot last night averaged 6.6mm for 3 shots and 16mm for 5 shots. Not bad at all for a factory standard M10FP /ubbthreads/images/graemlins/grin.gif .</p></blockquote><p></p>
[QUOTE="IceSniper, post: 103085, member: 2286"] Today i went to reload 15 rounds that i fired last night and after resizing i noticed my case trimmer wouldn't fit in the necks of 12 of them [img]/ubbthreads/images/graemlins/confused.gif[/img] , I tryed resizing them again but it made no diffrence. Then thinking something had gone wrong with my die i cleaned it out and tryed again with no success. Finally i tryed depriming/resizing some winchester brass and my cutter fit fine. So if it's not the die or the cutter it must be the cases. But then my expander ball should pull the neck open on the up stroke regardless, yes? I'm confused. What could be causing this and how do i fix it? I can't give measurements because i still haven't brought a caliper [img]/ubbthreads/images/graemlins/blush.gif[/img] . As a side note the 3x 5-shot groups i shot last night averaged 6.6mm for 3 shots and 16mm for 5 shots. Not bad at all for a factory standard M10FP [img]/ubbthreads/images/graemlins/grin.gif[/img] . [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Brass Problem
Top