Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Brass a bit stiff when chambering....at my wits end. Help!
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="oneeyejohn" data-source="post: 1951855" data-attributes="member: 85797"><p>I had this problem when using GI brass in my 30-06. I tried every thing could find reading, talking and talking to myself. I used a hornady datum line gauge and could not get the shoulder to set any deeper.</p><p>Finely I ground about a 1/16" of the bottom of the die and screwed it down to resized a case until it would feed and close like normal factory loads. I have found the same problem with custom chambers and ground of the die bottom to fix the problem. My problem with the case that is hard to load is almost always a datum line problem.</p></blockquote><p></p>
[QUOTE="oneeyejohn, post: 1951855, member: 85797"] I had this problem when using GI brass in my 30-06. I tried every thing could find reading, talking and talking to myself. I used a hornady datum line gauge and could not get the shoulder to set any deeper. Finely I ground about a 1/16" of the bottom of the die and screwed it down to resized a case until it would feed and close like normal factory loads. I have found the same problem with custom chambers and ground of the die bottom to fix the problem. My problem with the case that is hard to load is almost always a datum line problem. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Brass a bit stiff when chambering....at my wits end. Help!
Top