Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Chatting and General Stuff
General Discussion
Bore Guide Idea
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Jud96" data-source="post: 2898601" data-attributes="member: 69478"><p>Hey all, I am working on a modular bore guide idea. My goal is to make a bore guide equal to anything on the market with the ability to simply swap a couple parts and it will work with a large variety of actions and cartridges. I have made a couple prototypes from Delrin, but they're not where I want them to be. I had an idea to use aluminum for the bore guide and the section that will be in the action. How do you guys feel about a 6061 aluminum bore guide inside of the action? I feel better about the Delrin, but for the idea I am wanting to do, I feel the aluminum will be better for machinability and holding tolerances in a production setting. Any input would be very much valued! Thank you!</p></blockquote><p></p>
[QUOTE="Jud96, post: 2898601, member: 69478"] Hey all, I am working on a modular bore guide idea. My goal is to make a bore guide equal to anything on the market with the ability to simply swap a couple parts and it will work with a large variety of actions and cartridges. I have made a couple prototypes from Delrin, but they're not where I want them to be. I had an idea to use aluminum for the bore guide and the section that will be in the action. How do you guys feel about a 6061 aluminum bore guide inside of the action? I feel better about the Delrin, but for the idea I am wanting to do, I feel the aluminum will be better for machinability and holding tolerances in a production setting. Any input would be very much valued! Thank you! [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Chatting and General Stuff
General Discussion
Bore Guide Idea
Top