Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Chatting and General Stuff
General Discussion
Bolt hard to close
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Bravo 4" data-source="post: 2289620" data-attributes="member: 8873"><p>To check if it's an issue with the shoulder not sized back enough for your chamber, maybe color the entire shoulder with a marker and chamber. Then look for shiny spots where the marker was rubbed off.</p><p>If the OAL (over all length of the loaded cartridge) is too long, you can check it the same way buy using the marker on the bullet ogive/bearing surface junction. If the bullet is being jammed into the lands you will see it.</p><p>Or sacrifice one round and pull the bullet and dump the powder, then chamber and see if the problem still exists with just the case.</p></blockquote><p></p>
[QUOTE="Bravo 4, post: 2289620, member: 8873"] To check if it’s an issue with the shoulder not sized back enough for your chamber, maybe color the entire shoulder with a marker and chamber. Then look for shiny spots where the marker was rubbed off. If the OAL (over all length of the loaded cartridge) is too long, you can check it the same way buy using the marker on the bullet ogive/bearing surface junction. If the bullet is being jammed into the lands you will see it. Or sacrifice one round and pull the bullet and dump the powder, then chamber and see if the problem still exists with just the case. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Chatting and General Stuff
General Discussion
Bolt hard to close
Top