Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Chatting and General Stuff
General Discussion
Bolt Bore Reaming
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="kregg" data-source="post: 70061" data-attributes="member: 2385"><p>i havent had any rem actions that sloppy 0.705 cleans the one's that i have done up. you could have greg make you one that would cut 0.710 i did have one grab on me one time and after that i started to ream them driffrent. i dont run the cutter all the way threw the action, i cut one and pull it out and go to the other end of the action and put the cutter in and cut it because the other end of the action has be opened up to 0.705 so i put a 0.705 bushing in that end and were your cutter is cutting have a bushing there that fits tight and it cuts over the ramp with no promblem but i make sure my rpm's are pretty fast when i push it threw with oil on the cutter.</p></blockquote><p></p>
[QUOTE="kregg, post: 70061, member: 2385"] i havent had any rem actions that sloppy 0.705 cleans the one's that i have done up. you could have greg make you one that would cut 0.710 i did have one grab on me one time and after that i started to ream them driffrent. i dont run the cutter all the way threw the action, i cut one and pull it out and go to the other end of the action and put the cutter in and cut it because the other end of the action has be opened up to 0.705 so i put a 0.705 bushing in that end and were your cutter is cutting have a bushing there that fits tight and it cuts over the ramp with no promblem but i make sure my rpm's are pretty fast when i push it threw with oil on the cutter. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Chatting and General Stuff
General Discussion
Bolt Bore Reaming
Top