med358-boise
Well-Known Member
Browning Takedown BLR in 30-06. Rifle is very accurate and shoots sub 2/3 MOA. The 3shot group in the pic is .55 for Load 2. Shots for Load 1 were fired to confirm POI for some extra ammo.
Blueing overall is very good. Only minor imperfections to faint to show in photos.
The gun has been hunted and the stock has commensurate "dings and nicks" identified in the photos below (apologies I am not a good photographer):
1. The mark on the left side at the front of the comb (shaped like a grain of rice, the large light colored area is a reflection)
2. The vertical mark on the lower portion of the buttstock.
3. The various "pin marks" on the right side of the stock. These do not go into the wood but the nature of the high gloss finish causes small nicks to reflect light and show up
4. The right side of the forend where it meets the action
5. The left near the forend where it meets the action
6. Underside near the front sling swivel stud
Trigger has been worked by Neil Jones and average of 5 pulls was 4.25 lbs.
I have an extra magazine that I will include as well as a one piece base standard base and a set of two steel piece weaver bases. Gun currently has weaver aluminum two piece bases installed.
Currently, has a red thin fiber front sight and I will include the original also.
$950 (via PMO or Venmo) shipped in the lower 48 via Ship My Gun.
If your FFL won't participate in Ship My Gun, then buyer pays difference of shipping over $50. If shipping is less than $50, I will refund the difference.
Please PM with any questions
Blueing overall is very good. Only minor imperfections to faint to show in photos.
The gun has been hunted and the stock has commensurate "dings and nicks" identified in the photos below (apologies I am not a good photographer):
1. The mark on the left side at the front of the comb (shaped like a grain of rice, the large light colored area is a reflection)
2. The vertical mark on the lower portion of the buttstock.
3. The various "pin marks" on the right side of the stock. These do not go into the wood but the nature of the high gloss finish causes small nicks to reflect light and show up
4. The right side of the forend where it meets the action
5. The left near the forend where it meets the action
6. Underside near the front sling swivel stud
Trigger has been worked by Neil Jones and average of 5 pulls was 4.25 lbs.
I have an extra magazine that I will include as well as a one piece base standard base and a set of two steel piece weaver bases. Gun currently has weaver aluminum two piece bases installed.
Currently, has a red thin fiber front sight and I will include the original also.
$950 (via PMO or Venmo) shipped in the lower 48 via Ship My Gun.
If your FFL won't participate in Ship My Gun, then buyer pays difference of shipping over $50. If shipping is less than $50, I will refund the difference.
Please PM with any questions
Attachments
Last edited:
