Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Blown primers on 6.5 CM-Problem Solved on page 6!
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="bomberodevil" data-source="post: 2646453" data-attributes="member: 23175"><p>Problem solved. Re-measured my CBTO and COAL, today's measurements were within .003" of last week's measurements. Still scratching my head on how this load was so much hotter than a couple of loads I've already developed with pretty much the same system.</p><p></p><p>Was looking through my notes page from last week, and there it was. I inadvertently added my .030" off the lands back into my math! I was on the lands! Stupid and sloppy math, my fault completely.</p><p></p><p>Double and triple check your math! Thanks to all who passed along great advice and tips.</p></blockquote><p></p>
[QUOTE="bomberodevil, post: 2646453, member: 23175"] Problem solved. Re-measured my CBTO and COAL, today’s measurements were within .003” of last week’s measurements. Still scratching my head on how this load was so much hotter than a couple of loads I’ve already developed with pretty much the same system. Was looking through my notes page from last week, and there it was. I inadvertently added my .030” off the lands back into my math! I was on the lands! Stupid and sloppy math, my fault completely. Double and triple check your math! Thanks to all who passed along great advice and tips. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Blown primers on 6.5 CM-Problem Solved on page 6!
Top