Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Blown primers on 6.5 CM-Problem Solved on page 6!
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="cajun" data-source="post: 2645374" data-attributes="member: 9772"><p>99.9% the brass. Internal volume can make a big difference. You need to start lower when changing components. The data is just a guide and only good for the exact components in that barrel. Next time run a one shot ladder to find max pressure. You can even spot the nodes by finding where the velocity flattens and the shots on target cluster. Also .7 grains is not enough. Start at the low end.</p></blockquote><p></p>
[QUOTE="cajun, post: 2645374, member: 9772"] 99.9% the brass. Internal volume can make a big difference. You need to start lower when changing components. The data is just a guide and only good for the exact components in that barrel. Next time run a one shot ladder to find max pressure. You can even spot the nodes by finding where the velocity flattens and the shots on target cluster. Also .7 grains is not enough. Start at the low end. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Blown primers on 6.5 CM-Problem Solved on page 6!
Top