Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Bench recommendations
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="hunter0528" data-source="post: 2326916" data-attributes="member: 56641"><p>One thing I did on my bench was to add a 3/8's steel plate 12"x48" mounted at the corners. I then drilled and tapped the steel for my different presses, so I did not have a bunch of Holes in the wood. The holes in the steel plate I tapped I put cap screws to keep then clean. when I change pressed I just use a small vaccume to clean the Hex head holes and mount the other press. No flexing in the table or presses.</p></blockquote><p></p>
[QUOTE="hunter0528, post: 2326916, member: 56641"] One thing I did on my bench was to add a 3/8's steel plate 12"x48" mounted at the corners. I then drilled and tapped the steel for my different presses, so I did not have a bunch of Holes in the wood. The holes in the steel plate I tapped I put cap screws to keep then clean. when I change pressed I just use a small vaccume to clean the Hex head holes and mount the other press. No flexing in the table or presses. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Bench recommendations
Top