Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Belted Magnum Headspace
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="wmterry89" data-source="post: 1533831" data-attributes="member: 60552"><p>I purchased a 300 Weatherby take off barrel for a CRF model 70 to replace a 7mm Mag barrel. In comparing the barrels the 300s chamber is .003" deeper than the 7mm. With either barrel on the receiver, the bolt won't close on the GO gauge, but will close easily on a factory cartridge.</p><p></p><p>It seems to me that the 300 Wby barrel is good to go without any machining, but I'd like a second opinion.</p></blockquote><p></p>
[QUOTE="wmterry89, post: 1533831, member: 60552"] I purchased a 300 Weatherby take off barrel for a CRF model 70 to replace a 7mm Mag barrel. In comparing the barrels the 300s chamber is .003” deeper than the 7mm. With either barrel on the receiver, the bolt won’t close on the GO gauge, but will close easily on a factory cartridge. It seems to me that the 300 Wby barrel is good to go without any machining, but I’d like a second opinion. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Belted Magnum Headspace
Top