Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Bedding a Parker Hale Mauser???
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Apex Custom Rifles" data-source="post: 621304" data-attributes="member: 19307"><p>No, sorry I don't really have any photos of mine right off hand. The easiest way to go about it is to bed the entire area under the front ring back to the front of the mag box and however far on the barrel you want, then the rear tang area which ends up being not a whole lot of area, but with the pillar job will hold the tang area tight. </p><p> </p><p>Same thing goes for the trigger guard. </p><p> </p><p>You can do the entire action, but it is not needed, especially if it is a normal weight barrel. I figure while I'm there doing all the work, I might as well do the entire thing.</p></blockquote><p></p>
[QUOTE="Apex Custom Rifles, post: 621304, member: 19307"] No, sorry I don't really have any photos of mine right off hand. The easiest way to go about it is to bed the entire area under the front ring back to the front of the mag box and however far on the barrel you want, then the rear tang area which ends up being not a whole lot of area, but with the pillar job will hold the tang area tight. Same thing goes for the trigger guard. You can do the entire action, but it is not needed, especially if it is a normal weight barrel. I figure while I'm there doing all the work, I might as well do the entire thing. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Bedding a Parker Hale Mauser???
Top