Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Bedding 2 piece bottom metal
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Edd" data-source="post: 1553748" data-attributes="member: 30592"><p>When I bed one piece steel bottom metal, I use magnets to hold the front and rear of the metal flush with the stock. I don't see why you couldn't use the same method on a two piece setup. The magnets I use are 1/4" wide, 1-1/2" long, and 1/8" thick. They are so strong you have to handle them carefully.</p></blockquote><p></p>
[QUOTE="Edd, post: 1553748, member: 30592"] When I bed one piece steel bottom metal, I use magnets to hold the front and rear of the metal flush with the stock. I don't see why you couldn't use the same method on a two piece setup. The magnets I use are 1/4" wide, 1-1/2" long, and 1/8" thick. They are so strong you have to handle them carefully. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Bedding 2 piece bottom metal
Top