Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Bearing Surface Length Measurement Question
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Mikecr" data-source="post: 131729" data-attributes="member: 1521"><p>Well, I'll concede that the Sinclair does have the same hole IDs as The Buhay/BSC. Just measured best I could with calipers(don't have pin guages here). Looks like 24cal holes are .239", and 26cal holes are .260".</p><p></p><p>Seems like these are larger than typical bore diameters, but not as close to 'caliber' as I assumed(there's that dirty word). The Sinclair tool is good.</p><p></p><p>Hope I didn't mess ya up</p></blockquote><p></p>
[QUOTE="Mikecr, post: 131729, member: 1521"] Well, I'll concede that the Sinclair does have the same hole IDs as The Buhay/BSC. Just measured best I could with calipers(don't have pin guages here). Looks like 24cal holes are .239", and 26cal holes are .260". Seems like these are larger than typical bore diameters, but not as close to 'caliber' as I assumed(there's that dirty word). The Sinclair tool is good. Hope I didn't mess ya up [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Bearing Surface Length Measurement Question
Top