Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Barrel too small for 1/2" threadding?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="J E Custom" data-source="post: 1701495" data-attributes="member: 2736"><p>That's enough as long as the bore diameter is small enough to leave .150 barrel wall on each side. The brake can be built to seat against the muzzle</p><p>to get the same results.</p><p></p><p>If the caliber is .224 you will be Ok, it needs a barrel diameter of .563 and you are just below the minimum with a 1/2" thread. if you go to a 32 TPI Pitch thread It will help.</p><p></p><p>J E CUSTOM</p></blockquote><p></p>
[QUOTE="J E Custom, post: 1701495, member: 2736"] That's enough as long as the bore diameter is small enough to leave .150 barrel wall on each side. The brake can be built to seat against the muzzle to get the same results. If the caliber is .224 you will be Ok, it needs a barrel diameter of .563 and you are just below the minimum with a 1/2" thread. if you go to a 32 TPI Pitch thread It will help. J E CUSTOM [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Barrel too small for 1/2" threadding?
Top