Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Badlands BD-2 load data
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Mike Matteson" data-source="post: 2771534" data-attributes="member: 101791"><p>That's the way I understand it and do it with new brass. Fired brass I size and use a mandrel to push the uneveness to the outside then cut to length. Then cut for thickness.</p><p> It's take me 4 steps to necks down from 7mm to 6mm. I cut for thickness in 2 setups. Step down twice, anneal and finish up. So far I' ve been able to acheive tension at the time. The Smith want a few case to test fire. Found my neck is a little smaller ID than want by .0005. So I am cutting the thckness to .00125. Smith moved his shop, and I didn't have the blank to chamber for the seating die. I have a Gen-3 for length, and a 21st ctr to cut the thickness. </p><p>It's kind of been one delay after another here as of late. Looks like I am good to go! Live and learn. Thanks again.</p></blockquote><p></p>
[QUOTE="Mike Matteson, post: 2771534, member: 101791"] That's the way I understand it and do it with new brass. Fired brass I size and use a mandrel to push the uneveness to the outside then cut to length. Then cut for thickness. It's take me 4 steps to necks down from 7mm to 6mm. I cut for thickness in 2 setups. Step down twice, anneal and finish up. So far I' ve been able to acheive tension at the time. The Smith want a few case to test fire. Found my neck is a little smaller ID than want by .0005. So I am cutting the thckness to .00125. Smith moved his shop, and I didn't have the blank to chamber for the seating die. I have a Gen-3 for length, and a 21st ctr to cut the thickness. It's kind of been one delay after another here as of late. Looks like I am good to go! Live and learn. Thanks again. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Badlands BD-2 load data
Top