Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Bad bottom metal inlet question
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Tucker65" data-source="post: 2261572" data-attributes="member: 13818"><p>Shim would work but I would just bed the whole bottom metal to the stock. It would be no different then bedding the barreled action on the top side. Wrap a layer or two of tape around the perimeter of the bottom metal and put plenty of release agent on it. Then you just need to find a way to support the bottom metal at the right height. I've done this once before by putting a couple of really small diameter brads on each side of the pillar. Tap them in to get the correct height and then glass bed the bottom metal in.</p></blockquote><p></p>
[QUOTE="Tucker65, post: 2261572, member: 13818"] Shim would work but I would just bed the whole bottom metal to the stock. It would be no different then bedding the barreled action on the top side. Wrap a layer or two of tape around the perimeter of the bottom metal and put plenty of release agent on it. Then you just need to find a way to support the bottom metal at the right height. I've done this once before by putting a couple of really small diameter brads on each side of the pillar. Tap them in to get the correct height and then glass bed the bottom metal in. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Bad bottom metal inlet question
Top