Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Anyone have any tricks for adjusting POI consistency across multiple loads?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="300magman" data-source="post: 1034420" data-attributes="member: 24769"><p>Well, I can always experiment a bit. I'm not opposed to playing around with a grain more or less powder on the reduced loads to see where it takes me.</p><p> </p><p>I was also talking to a steel silhouette shooter who had the forward stock on his marlin lever in 357Mag epoxy bedded to make continuous contact with the barrel for the entire length of the forward stock. He claimed it made a noticeable difference in his groups. . . I might try that, if it is possible without permanently gluing the stock on; though I might first just try half the length. Perhaps it will favorably stabilize the barrels harmonics across the full range.</p><p> </p><p>Any input on whether or not it would be worth experimenting with adjusting the seating depth across the Very Narrow window that the bullets seating bands might allow for, or would such a small adjustment typically not yield much of a change in the load considering the bullets are already no where near the lands and a few thousandths of an inch closer wouldn't even equal a 1% adjustment.</p></blockquote><p></p>
[QUOTE="300magman, post: 1034420, member: 24769"] Well, I can always experiment a bit. I'm not opposed to playing around with a grain more or less powder on the reduced loads to see where it takes me. I was also talking to a steel silhouette shooter who had the forward stock on his marlin lever in 357Mag epoxy bedded to make continuous contact with the barrel for the entire length of the forward stock. He claimed it made a noticeable difference in his groups. . . I might try that, if it is possible without permanently gluing the stock on; though I might first just try half the length. Perhaps it will favorably stabilize the barrels harmonics across the full range. Any input on whether or not it would be worth experimenting with adjusting the seating depth across the Very Narrow window that the bullets seating bands might allow for, or would such a small adjustment typically not yield much of a change in the load considering the bullets are already no where near the lands and a few thousandths of an inch closer wouldn't even equal a 1% adjustment. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Anyone have any tricks for adjusting POI consistency across multiple loads?
Top