Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Another 7mm-08 Question
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="gbett308" data-source="post: 1880601" data-attributes="member: 104935"><p>Alright, I looked at the sizing die again and it was not adjusted correctly. So I was thinking after adjusting that would resolve the issue so I resized some brass and reloaded a couple cartridges. Would you believe the same problem? The bolt is difficult to close still but closes. I tried some factory ammo and fit is good, no issues. I checked the coal of the cartridge and it was 2.812, a little over so I seated the bullet deeper at 2.775 resulting in same issue. Diameter of case within specs, mine .466 and factory ,461. I checked some other reloads and some load ok and other are hard on the bolt. All the case were trimmed to specs, no over max or compressed loads. I even re-cleaned the chamber out...anyone have any thoughts?</p></blockquote><p></p>
[QUOTE="gbett308, post: 1880601, member: 104935"] Alright, I looked at the sizing die again and it was not adjusted correctly. So I was thinking after adjusting that would resolve the issue so I resized some brass and reloaded a couple cartridges. Would you believe the same problem? The bolt is difficult to close still but closes. I tried some factory ammo and fit is good, no issues. I checked the coal of the cartridge and it was 2.812, a little over so I seated the bullet deeper at 2.775 resulting in same issue. Diameter of case within specs, mine .466 and factory ,461. I checked some other reloads and some load ok and other are hard on the bolt. All the case were trimmed to specs, no over max or compressed loads. I even re-cleaned the chamber out...anyone have any thoughts? [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Another 7mm-08 Question
Top