Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Annealing timing question
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="dok7mm" data-source="post: 1469765" data-attributes="member: 90080"><p>FWIW....... I found a Forester FL 300wm die that minimally sizes my brass. I pulled the expander stem out of it and used it as a body die. Ran some fired brass thru it.........perfect .002 reduction. The kicker was it also sized the neck down to .305" I.D. or .003 interference fit. Just had to expand it up .001". Worked much better than my Redding body die, for $20.00 on closeout.</p></blockquote><p></p>
[QUOTE="dok7mm, post: 1469765, member: 90080"] FWIW....... I found a Forester FL 300wm die that minimally sizes my brass. I pulled the expander stem out of it and used it as a body die. Ran some fired brass thru it.........perfect .002 reduction. The kicker was it also sized the neck down to .305" I.D. or .003 interference fit. Just had to expand it up .001". Worked much better than my Redding body die, for $20.00 on closeout. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Annealing timing question
Top