Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Annealing before or after sizing?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="ButterBean" data-source="post: 1952633" data-attributes="member: 41385"><p>That's your opinion and you are entitled to it but you are incorrect, It can be done, lots of folks do it this way and as I said I did it for years, you have to be paying attention but the heat will not travel to the cartridge head in 7 seconds, 8-9 yes but not at seven, to tell a man he is wasting his time when you have never done this yourself is what has been the demise of this forum for the last few years, once again no disrespect intended but certainly can be done and done correctly holding it your hand with a torch, that will be my last word on the subject</p></blockquote><p></p>
[QUOTE="ButterBean, post: 1952633, member: 41385"] That’s your opinion and you are entitled to it but you are incorrect, It can be done, lots of folks do it this way and as I said I did it for years, you have to be paying attention but the heat will not travel to the cartridge head in 7 seconds, 8-9 yes but not at seven, to tell a man he is wasting his time when you have never done this yourself is what has been the demise of this forum for the last few years, once again no disrespect intended but certainly can be done and done correctly holding it your hand with a torch, that will be my last word on the subject [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Annealing before or after sizing?
Top