Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Muzzleloader Hunting
And down the rabbit hole I go….
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="jensenj71" data-source="post: 2953009" data-attributes="member: 96797"><p>I was surprised to see how crappy the action was fit to the stock on my Paramount Colorado. The stock must have been dipped and setup to dry upside down. The action was setting on 3 or 4 random lumpy drips. I sanded down the drips with a 24mm socket wrapped with sand paper. The back of the action at the rear screw wasn't touching the stock with the front action screw snugged up. Tightening rear screw was flexing the stock and action 0.1". I bedded the back tab around the rear action screw and the face of the recoil lug with the front action screw snug but not tight for a temporary fix. I have some Devcon on order so that I can fully bed the action over the holidays. I am hoping the quick improvements in bedding improve groups at 200yds and support stretching out to 300yds. Shooting Fury 320gr with 108wgr of BH209 and Arrowhead ignition with CCI 250 at 2200fps with a 15fps ES.</p></blockquote><p></p>
[QUOTE="jensenj71, post: 2953009, member: 96797"] I was surprised to see how crappy the action was fit to the stock on my Paramount Colorado. The stock must have been dipped and setup to dry upside down. The action was setting on 3 or 4 random lumpy drips. I sanded down the drips with a 24mm socket wrapped with sand paper. The back of the action at the rear screw wasn't touching the stock with the front action screw snugged up. Tightening rear screw was flexing the stock and action 0.1". I bedded the back tab around the rear action screw and the face of the recoil lug with the front action screw snug but not tight for a temporary fix. I have some Devcon on order so that I can fully bed the action over the holidays. I am hoping the quick improvements in bedding improve groups at 200yds and support stretching out to 300yds. Shooting Fury 320gr with 108wgr of BH209 and Arrowhead ignition with CCI 250 at 2200fps with a 15fps ES. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Muzzleloader Hunting
And down the rabbit hole I go….
Top