Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Air Compressor - Piping for Gunsmithing Equipment
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Coyote Shadow Tracker" data-source="post: 2534250" data-attributes="member: 116439"><p>We have been renovating out shop (seems like forever with my spinal cord injury). Getting ready to put some permanent Compressed Air Lines throughout the shop. Reloading area, Lathe/Mill/Drill/Saw area, and Cerakote Spray Booth & Blasing Station. Currently running rubber hoses and when putting more permanent lines in what is the best material to use? I looked at steel, but hard to work with and threading, PVC Scheduled 40 seems like a bad idea because of plastic break down. Looking at Copper. Type "L" is rated at 1,000psi and Type "M is 700 psi. Big difference in price. Our Compressor is a Quincy Two Stage, Four Cylinder, 5 HP, 60 Gallon and 175 psi. I Installed an After Cooler on the compressor between the compressor and tank with water separator/filter then have 60' of copper pipe in several 7' sections to act as a dryer with drains on each section. After that the air goes into an Advanced 3-in-1 compressed air dryer system features modes for pre-refrigeration, evaporation, and air and moisture separation. </p><p>Then I need to get the Filtered/Clean/Moisture Free air to the stations.</p><p>What is the piping you may be using?</p><p></p><p>Thanks</p><p>Len & Jill</p></blockquote><p></p>
[QUOTE="Coyote Shadow Tracker, post: 2534250, member: 116439"] We have been renovating out shop (seems like forever with my spinal cord injury). Getting ready to put some permanent Compressed Air Lines throughout the shop. Reloading area, Lathe/Mill/Drill/Saw area, and Cerakote Spray Booth & Blasing Station. Currently running rubber hoses and when putting more permanent lines in what is the best material to use? I looked at steel, but hard to work with and threading, PVC Scheduled 40 seems like a bad idea because of plastic break down. Looking at Copper. Type "L" is rated at 1,000psi and Type "M is 700 psi. Big difference in price. Our Compressor is a Quincy Two Stage, Four Cylinder, 5 HP, 60 Gallon and 175 psi. I Installed an After Cooler on the compressor between the compressor and tank with water separator/filter then have 60' of copper pipe in several 7' sections to act as a dryer with drains on each section. After that the air goes into an Advanced 3-in-1 compressed air dryer system features modes for pre-refrigeration, evaporation, and air and moisture separation. Then I need to get the Filtered/Clean/Moisture Free air to the stations. What is the piping you may be using? Thanks Len & Jill [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Air Compressor - Piping for Gunsmithing Equipment
Top