Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Accuracy issue, Major bolt movement when bolt closed
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="huntforfood" data-source="post: 2591935" data-attributes="member: 114703"><p>I was getting tumbling bullets at 75 yds after putting a EC tuner brake on last time I shot it, stuff flying all over. I read about someone having similar issue questioning thread concentricity etc. with a brake and getting brake strikes. I just checked inside my ec tuner and I have strike on bottom edge about 1 inch before exit. I checked barrel with a light and I see chatter marks on last few inches at end off barrel now, as it is heavily fouled. I see jacket copper in last inch of barrel too. The more I look the worse it gets, lol. Weatherby is getting this back. Also, the B&C stock was a mess. The aluminum bedding block holes were both off center and the lug hole was not a thru hole and was threading the front screw. I bored out and improved but shouldn't be this difficult. I free floated so its a warranty void, but I could care less about stock, barrel and bolt have to be right.</p></blockquote><p></p>
[QUOTE="huntforfood, post: 2591935, member: 114703"] I was getting tumbling bullets at 75 yds after putting a EC tuner brake on last time I shot it, stuff flying all over. I read about someone having similar issue questioning thread concentricity etc. with a brake and getting brake strikes. I just checked inside my ec tuner and I have strike on bottom edge about 1 inch before exit. I checked barrel with a light and I see chatter marks on last few inches at end off barrel now, as it is heavily fouled. I see jacket copper in last inch of barrel too. The more I look the worse it gets, lol. Weatherby is getting this back. Also, the B&C stock was a mess. The aluminum bedding block holes were both off center and the lug hole was not a thru hole and was threading the front screw. I bored out and improved but shouldn't be this difficult. I free floated so its a warranty void, but I could care less about stock, barrel and bolt have to be right. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Accuracy issue, Major bolt movement when bolt closed
Top