Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Absolute Hammer load data
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Hard rock" data-source="post: 2266689" data-attributes="member: 116620"><p>Here are some results of a 25-284 1-8 twist 25in Barrell I've been working a load up for , Hammer 90 gr absolutes cci200 lr primer Lapua 6.5 -284 brass necked down with 6.5 284 Redding bushing dies using a . 283 bushing oal 2.880 with H4350 57gr 3595 fps 57.5 grs 3626 fps 58 grs 3667 fps 58.5 grs3693 fps 59 grs 3774 fps very faint ejecter mark 59.5 grs 3816 fps ejecter mark leaky primer . 004 neck tension no crimp . I had easy bolt lift through out pressure test but feel this as far as should go with H4350 . This is new brass so after it is formed too chamber i might could get a little more out of it but I'm going to work on a load between 57 grs and 58.5 any advice welcomed hope this all the info that's needed too post thanks. Note the 6.5-284 bushing dies with a . 283 bushing necks down too 25-284 with no problem at all .</p></blockquote><p></p>
[QUOTE="Hard rock, post: 2266689, member: 116620"] Here are some results of a 25-284 1-8 twist 25in Barrell I've been working a load up for , Hammer 90 gr absolutes cci200 lr primer Lapua 6.5 -284 brass necked down with 6.5 284 Redding bushing dies using a . 283 bushing oal 2.880 with H4350 57gr 3595 fps 57.5 grs 3626 fps 58 grs 3667 fps 58.5 grs3693 fps 59 grs 3774 fps very faint ejecter mark 59.5 grs 3816 fps ejecter mark leaky primer . 004 neck tension no crimp . I had easy bolt lift through out pressure test but feel this as far as should go with H4350 . This is new brass so after it is formed too chamber i might could get a little more out of it but I'm going to work on a load between 57 grs and 58.5 any advice welcomed hope this all the info that's needed too post thanks. Note the 6.5-284 bushing dies with a . 283 bushing necks down too 25-284 with no problem at all . [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Absolute Hammer load data
Top