Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
A twist on barrel break in question...... Bullet seating depth....
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="TwoMore" data-source="post: 1438798" data-attributes="member: 95166"><p>I have only chambered a few dozen Barrels so I have to admit I think about the finish of the throat and how to make it less abrasive during break-in. specially with the longer leads and cuts with bore-riders that I have been doing lately. I have lightly smoothed up the throat with JB before<img src="data:image/gif;base64,R0lGODlhAQABAIAAAAAAAP///yH5BAEAAAAALAAAAAABAAEAAAIBRAA7" class="smilie smilie--sprite smilie--sprite10" alt=":oops:" title="Oops! :oops:" loading="lazy" data-shortname=":oops:" />. but have noticed that even those longer cut lands break in close to the same time as shorter throated barrels so I have just been doing the one shot and clean method. One thing I notice is when you are getting close to the end of the chambering process, going slow with plenty of cutting fluid and dont let the reamer load up with chips leaves a better finish</p></blockquote><p></p>
[QUOTE="TwoMore, post: 1438798, member: 95166"] I have only chambered a few dozen Barrels so I have to admit I think about the finish of the throat and how to make it less abrasive during break-in. specially with the longer leads and cuts with bore-riders that I have been doing lately. I have lightly smoothed up the throat with JB before:oops:. but have noticed that even those longer cut lands break in close to the same time as shorter throated barrels so I have just been doing the one shot and clean method. One thing I notice is when you are getting close to the end of the chambering process, going slow with plenty of cutting fluid and dont let the reamer load up with chips leaves a better finish [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
A twist on barrel break in question...... Bullet seating depth....
Top