Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
A slightly different question on breaking in a BBL
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Waltech Jim" data-source="post: 89516" data-attributes="member: 3214"><p>4ked Horn,</p><p></p><p>Good question. Just thinking out loud here. IF breaking in a barrel is super heating the transverse ridges left by the reamer in the throat area. And then these ridges are "smoothed" by the powder and expanding gases, would a reduced load accomplish this better/faster than a normal load. </p><p></p><p>JMO, I think it would take longer. Is there an advantage to that? Not sure there is. </p><p></p><p>OK how was that for a definitive answer? </p><p></p><p>Jim</p></blockquote><p></p>
[QUOTE="Waltech Jim, post: 89516, member: 3214"] 4ked Horn, Good question. Just thinking out loud here. IF breaking in a barrel is super heating the transverse ridges left by the reamer in the throat area. And then these ridges are "smoothed" by the powder and expanding gases, would a reduced load accomplish this better/faster than a normal load. JMO, I think it would take longer. Is there an advantage to that? Not sure there is. OK how was that for a definitive answer? Jim [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
A slightly different question on breaking in a BBL
Top