Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
A newcomers perspective/guide into Customs and reloading
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Taylorbok" data-source="post: 2363108" data-attributes="member: 118538"><p>1/10 that is a lot. I have doubt.</p><p></p><p>Check over all your fasteners to make sure they are torqued. Maybe the scope is bad try swapping it out. Also I put one of those terminator breaks onto a barrell that was already threaded and it was throwing bullets like crazy, I couldn't see where the bullet was contacting the brake, I ended up selling it to a buddy and it's fine on his rifle.</p><p></p><p>What is different about your chamber vs saami spec? (i'm not sure what 3.68" cut is supposed to mean)</p><p>I am assuming all you changed was the Freebore. You can still shoot factory ammo it will just jump a mile which isn't bad.</p><p></p><p>Maybe your loading is bad.</p><p></p><p>can you truely shoot? I was developing a load for a buddy. He shot the first group at like 2.5". I said ***? I shot 3 of the same and it was like .75 not great but not bad. I realized no sense letting him shoot the test ammo if he can't shoot.</p></blockquote><p></p>
[QUOTE="Taylorbok, post: 2363108, member: 118538"] 1/10 that is a lot. I have doubt. Check over all your fasteners to make sure they are torqued. Maybe the scope is bad try swapping it out. Also I put one of those terminator breaks onto a barrell that was already threaded and it was throwing bullets like crazy, I couldn't see where the bullet was contacting the brake, I ended up selling it to a buddy and it's fine on his rifle. What is different about your chamber vs saami spec? (i'm not sure what 3.68" cut is supposed to mean) I am assuming all you changed was the Freebore. You can still shoot factory ammo it will just jump a mile which isn't bad. Maybe your loading is bad. can you truely shoot? I was developing a load for a buddy. He shot the first group at like 2.5". I said ***? I shot 3 of the same and it was like .75 not great but not bad. I realized no sense letting him shoot the test ammo if he can't shoot. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
A newcomers perspective/guide into Customs and reloading
Top