Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
7mmSTW brass??
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Sako7STW" data-source="post: 31598" data-attributes="member: 2112"><p>Hello all, First post here, I am sure some of you may have seen me on a few other threads. </p><p></p><p>Well I figure the LD shooters would know there stuff on accurate big boomers. My question is do any of you know where one could find some high quality 7mmSTW brass or 8mm brass?</p><p></p><p>The brass I have now, not sure of make, is not that impressive. The knecks seam to vary greatly. I am going to pick me up a case trimmer and was also thinking about turning my knecks. I have never done that before. Is it difficult to do? Do you recommend doing this? And lastly what neck turner do you recommend?</p><p></p><p>Thank you for your time and consideration.</p><p></p><p>PS I have read on here a bit about the 7mmLapua Wildcat...Whats the difference between that and the Lazzeroni Firebird??</p></blockquote><p></p>
[QUOTE="Sako7STW, post: 31598, member: 2112"] Hello all, First post here, I am sure some of you may have seen me on a few other threads. Well I figure the LD shooters would know there stuff on accurate big boomers. My question is do any of you know where one could find some high quality 7mmSTW brass or 8mm brass? The brass I have now, not sure of make, is not that impressive. The knecks seam to vary greatly. I am going to pick me up a case trimmer and was also thinking about turning my knecks. I have never done that before. Is it difficult to do? Do you recommend doing this? And lastly what neck turner do you recommend? Thank you for your time and consideration. PS I have read on here a bit about the 7mmLapua Wildcat...Whats the difference between that and the Lazzeroni Firebird?? [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
7mmSTW brass??
Top