Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
7mm rem mag brass failure
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="baldhunter" data-source="post: 403593" data-attributes="member: 11853"><p>If your loading with IMR-4350,I'd drop down a couple of grains.I load 65.3grs of IMR-4350 and never had too much problem with case failure,in fact I've loaded some Remington cases at least a dozen times.I have heard that Federal brass is a little weak and I've only loaded a small amount of it over the years,I never really had any case failures,but it did seem to show pressure signs before the Remington brass did with the same load.I've had good luck with the Remington brass in the 7mag,you might try a few of those and see how it does.</p></blockquote><p></p>
[QUOTE="baldhunter, post: 403593, member: 11853"] If your loading with IMR-4350,I'd drop down a couple of grains.I load 65.3grs of IMR-4350 and never had too much problem with case failure,in fact I've loaded some Remington cases at least a dozen times.I have heard that Federal brass is a little weak and I've only loaded a small amount of it over the years,I never really had any case failures,but it did seem to show pressure signs before the Remington brass did with the same load.I've had good luck with the Remington brass in the 7mag,you might try a few of those and see how it does. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
7mm rem mag brass failure
Top