Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
7mm mag
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Barrelnut" data-source="post: 1472274" data-attributes="member: 74902"><p>Yes that's it! But you have to learn howto setup the Hornady Full length die so that it only bumps the should back ~2 thousands. You need the Hornady Headspace Gauge set mentioned above to effectively do that. You can also do it by setting up the FL die so that it is off the shell holder by a turn or so and keeping sizing the piece of brass and turning the die about 1/16 further down each time. After sizing the piece of brass try to fit it in the camber and turn the die down another 1/16 until the bolt just closes on the piece of brass with no resistance.</p></blockquote><p></p>
[QUOTE="Barrelnut, post: 1472274, member: 74902"] Yes that's it! But you have to learn howto setup the Hornady Full length die so that it only bumps the should back ~2 thousands. You need the Hornady Headspace Gauge set mentioned above to effectively do that. You can also do it by setting up the FL die so that it is off the shell holder by a turn or so and keeping sizing the piece of brass and turning the die about 1/16 further down each time. After sizing the piece of brass try to fit it in the camber and turn the die down another 1/16 until the bolt just closes on the piece of brass with no resistance. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
7mm mag
Top