Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
7 STW brass wont chamber
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="WRG" data-source="post: 284282" data-attributes="member: 13638"><p>I don't know whether your being sarcastic in your reply or not but had you said you have a custom barrel and you had cut one of the pieces in half to eliminate headspace as the cuplrit in your first post, I would have said just throw them in the trash or try to pawn them on some other poor soul with a factory barrel. Winchester most likely isn't going to do anything for you. That brass past last inspection and is within SAMMI spec I'll bet on it. Your custom barrel with tight tolerances is not Winchesters problem! I would be surprised to say the least if they took them back. Then again, they might because thats what good companies do, the customer is always right regardless. I would do like Buffalobob said and have the headspace reset on your rifle or your going to run into this problem all the time with new brass. That's the way it is when working with custom stuff against SAMMI specs. It can be a pain in the ***.</p><p> </p><p>WRG</p></blockquote><p></p>
[QUOTE="WRG, post: 284282, member: 13638"] I don't know whether your being sarcastic in your reply or not but had you said you have a custom barrel and you had cut one of the pieces in half to eliminate headspace as the cuplrit in your first post, I would have said just throw them in the trash or try to pawn them on some other poor soul with a factory barrel. Winchester most likely isn't going to do anything for you. That brass past last inspection and is within SAMMI spec I'll bet on it. Your custom barrel with tight tolerances is not Winchesters problem! I would be surprised to say the least if they took them back. Then again, they might because thats what good companies do, the customer is always right regardless. I would do like Buffalobob said and have the headspace reset on your rifle or your going to run into this problem all the time with new brass. That's the way it is when working with custom stuff against SAMMI specs. It can be a pain in the ***. WRG [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
7 STW brass wont chamber
Top