Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
6mm remington brass help
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="RegionRat" data-source="post: 1576140" data-attributes="member: 57231"><p>You can also take some of the other diameters off the cartridge drawing and see if you are over by comparing to the chamber drawings. Lengths and tapers are difficult to measure outside of a well equipped inspection lab, but basic diameters are not.</p><p></p><p>Using the ink method as recommended is a great starting point. </p><p></p><p>My visual guess is that the diameter right above where you see that "ring", when compared to your chamber is too large from being fired in a loose chamber, but that is a weak visual guess. See if the ink there indicates a suspicious point and then measure it.</p><p></p><p>If you have wet tumbled with pins, you can also see well enoug inside with jewelers magnifiers to see the issue and feel it with a bent paper clip. I hope it just needs to be sized down, but it isn't the end of the world if it is scrapped. I would mention that to the shop that sold it to you...</p></blockquote><p></p>
[QUOTE="RegionRat, post: 1576140, member: 57231"] You can also take some of the other diameters off the cartridge drawing and see if you are over by comparing to the chamber drawings. Lengths and tapers are difficult to measure outside of a well equipped inspection lab, but basic diameters are not. Using the ink method as recommended is a great starting point. My visual guess is that the diameter right above where you see that “ring”, when compared to your chamber is too large from being fired in a loose chamber, but that is a weak visual guess. See if the ink there indicates a suspicious point and then measure it. If you have wet tumbled with pins, you can also see well enoug inside with jewelers magnifiers to see the issue and feel it with a bent paper clip. I hope it just needs to be sized down, but it isn’t the end of the world if it is scrapped. I would mention that to the shop that sold it to you... [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
6mm remington brass help
Top