Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
6.5x284 load help
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Jezzro2004" data-source="post: 1230632" data-attributes="member: 38457"><p>Chambering is 6.5x284 Norma, I did some measuring on what I could this morning, I did noticed that some of my cartridge overall length did vary some from what it was most were 2.160" and no more than 2.164 I'd assume that could cause inconsistencies.. My Wilson neck die has a .293 bushing. I tried to post pictures of the brass O.D. Before and after sizing and the spent brass the bullet can be pushed in by fingers but it's kinda draggy. As for neck thickness I'm getting around .0165 -.0170. I don't have a go and no gauge for this caliber. I did post a couple of pics of the headspace on unfired Lapua brass and a round that has been fired 3 times with hot loads if that helps. My unfired brass measured 1.812 and the fired one was 1.8195. I couldn't get all the pics to load from my phone. The brass O.D was .296 before and .294 after sizing</p></blockquote><p></p>
[QUOTE="Jezzro2004, post: 1230632, member: 38457"] Chambering is 6.5x284 Norma, I did some measuring on what I could this morning, I did noticed that some of my cartridge overall length did vary some from what it was most were 2.160" and no more than 2.164 I'd assume that could cause inconsistencies.. My Wilson neck die has a .293 bushing. I tried to post pictures of the brass O.D. Before and after sizing and the spent brass the bullet can be pushed in by fingers but it's kinda draggy. As for neck thickness I'm getting around .0165 -.0170. I don't have a go and no gauge for this caliber. I did post a couple of pics of the headspace on unfired Lapua brass and a round that has been fired 3 times with hot loads if that helps. My unfired brass measured 1.812 and the fired one was 1.8195. I couldn't get all the pics to load from my phone. The brass O.D was .296 before and .294 after sizing [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
6.5x284 load help
Top