Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
6.5 PRC Discussion
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="BCJ" data-source="post: 2220752" data-attributes="member: 72187"><p>The problem is your chambering. The rear part of the chamber cut is .002 too small. Go check out long range only they have a good article on it regarding cases sticking. Also order a JGS AW2 reamer and it will fix the problem. I had some Hand loaded 135 ATips with all kinds of pressure issues with a new CA barrel and I honed the back of the chamber out and can now run them at 3080 with no pressure issues using H1000. I could not reproduce the same velocity as factory Hornady 147's (3000fps) with any loads until I fixed the rear of the chambering issue</p></blockquote><p></p>
[QUOTE="BCJ, post: 2220752, member: 72187"] The problem is your chambering. The rear part of the chamber cut is .002 too small. Go check out long range only they have a good article on it regarding cases sticking. Also order a JGS AW2 reamer and it will fix the problem. I had some Hand loaded 135 ATips with all kinds of pressure issues with a new CA barrel and I honed the back of the chamber out and can now run them at 3080 with no pressure issues using H1000. I could not reproduce the same velocity as factory Hornady 147’s (3000fps) with any loads until I fixed the rear of the chambering issue [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
6.5 PRC Discussion
Top