Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
6.5 prc brass discussion
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="BrentM" data-source="post: 2297676" data-attributes="member: 61747"><p>Can. I use a end mills. The only issue is that it shortens the bolt body a little and puts more pressure on the firing pin spring. With the amount you are removing it likely won't be that noticeable. When doing that you should probably reset the cocking button space to .080-.100 off the bottom of the ramp.</p></blockquote><p></p>
[QUOTE="BrentM, post: 2297676, member: 61747"] Can. I use a end mills. The only issue is that it shortens the bolt body a little and puts more pressure on the firing pin spring. With the amount you are removing it likely won't be that noticeable. When doing that you should probably reset the cocking button space to .080-.100 off the bottom of the ramp. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
6.5 prc brass discussion
Top