Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
6.5 Creed Reamer
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Crowe284" data-source="post: 1441078" data-attributes="member: 97064"><p>Hmmmmmmm.....I have a had a couple of factory Creedmoors and have loaded for a few others including a couple of customs and have never had a problem fitting the mag box...After load development with the 143 they have all liked to shoot at between 2.800 and 2.830. My current load for a rifle I just sold was 2.806 COAL and 2.166 CBTO and was a solid 1/4 minute rifle. Also, many prople report excellent accuracy with hornady factory ammo shot out of factory rifles with SAMMI chambers....I'm just making points about facts and am certainly open to good advice!</p><p></p><p>The sammi reamer has a freebore of .199, using the 143 eld x, at what COAL would it touch? I have seen others figure these dimensions, I just am not sure how.</p></blockquote><p></p>
[QUOTE="Crowe284, post: 1441078, member: 97064"] Hmmmmmmm.....I have a had a couple of factory Creedmoors and have loaded for a few others including a couple of customs and have never had a problem fitting the mag box...After load development with the 143 they have all liked to shoot at between 2.800 and 2.830. My current load for a rifle I just sold was 2.806 COAL and 2.166 CBTO and was a solid 1/4 minute rifle. Also, many prople report excellent accuracy with hornady factory ammo shot out of factory rifles with SAMMI chambers....I’m just making points about facts and am certainly open to good advice! The sammi reamer has a freebore of .199, using the 143 eld x, at what COAL would it touch? I have seen others figure these dimensions, I just am not sure how. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
6.5 Creed Reamer
Top