Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
375 Rum inconsistent pressure signs
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="chrisb97" data-source="post: 2825244" data-attributes="member: 102205"><p>Im running Magpro powder at 97.1 grains but im not sure of the fill ratio. And there's no flattening of the primer even on the rounds that exhibited the other pressure signs. I used cutting edges recommended seating depth because of the seal tite bore rider and it is just barely touching the lands. The chamber was cut for me to have a little bit of freebore for the 350 smk but i had to switch to the MTH as i just cant find any matchkings.</p></blockquote><p></p>
[QUOTE="chrisb97, post: 2825244, member: 102205"] Im running Magpro powder at 97.1 grains but im not sure of the fill ratio. And there's no flattening of the primer even on the rounds that exhibited the other pressure signs. I used cutting edges recommended seating depth because of the seal tite bore rider and it is just barely touching the lands. The chamber was cut for me to have a little bit of freebore for the 350 smk but i had to switch to the MTH as i just cant find any matchkings. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
375 Rum inconsistent pressure signs
Top