Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
.338 Sherman Short Mag build
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="El Matavenados" data-source="post: 1393592" data-attributes="member: 89192"><p>I think you are right. I chucked the reamer up into the mill, and noticed a lot of run-out. After running some tests, it looks like there is at least .0015" run-out in the spindle, and the reamer is pretty long, making it very obvious. If holding it lightly in my fingers doesn't produce acceptable results, I'll have to go a different route.</p><p></p><p>The fixture should work well for trimming, though.</p></blockquote><p></p>
[QUOTE="El Matavenados, post: 1393592, member: 89192"] I think you are right. I chucked the reamer up into the mill, and noticed a lot of run-out. After running some tests, it looks like there is at least .0015" run-out in the spindle, and the reamer is pretty long, making it very obvious. If holding it lightly in my fingers doesn't produce acceptable results, I'll have to go a different route. The fixture should work well for trimming, though. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
.338 Sherman Short Mag build
Top