Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
.338 M.O.A.G. (mother of all guns) pics and story
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="4ked Horn" data-source="post: 65490" data-attributes="member: 11"><p>Hey Brian would you care to tell me what the difference is between base to ogive and bearing surface is when you subtract the boat tail portion of the bullet. I mean, I can see that finding the <em>exact</em> tangent spot where the cylindrical portion meets the ogive might be a challenge and would require special gear to get it down to the .001". But the distance from the bottom of the bullet to the largest diameter couldn't be off by much could it? I would guess it would be less than .001".</p></blockquote><p></p>
[QUOTE="4ked Horn, post: 65490, member: 11"] Hey Brian would you care to tell me what the difference is between base to ogive and bearing surface is when you subtract the boat tail portion of the bullet. I mean, I can see that finding the [i]exact[/i] tangent spot where the cylindrical portion meets the ogive might be a challenge and would require special gear to get it down to the .001". But the distance from the bottom of the bullet to the largest diameter couldn't be off by much could it? I would guess it would be less than .001". [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
.338 M.O.A.G. (mother of all guns) pics and story
Top