Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
338 Lapua Improved 40 degree with print. Which design is better?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Pdvdh" data-source="post: 1083195" data-attributes="member: 4191"><p>I think you're in the ballpark. I went back and forth on Lead length. I think I settled on 0.225" for my .338 Lapua 37*. Which is essentially the same as what you decided to go with. A difference of 0.010" is insignificant when it comes to LEAD length. </p><p></p><p>Curious; did JGS have any comments on the shoulder diameter and case body taper on your reamer spec? Were they good with the 0.08805" taper/20 inches? Good luck on your rifle project!</p></blockquote><p></p>
[QUOTE="Pdvdh, post: 1083195, member: 4191"] I think you're in the ballpark. I went back and forth on Lead length. I think I settled on 0.225" for my .338 Lapua 37*. Which is essentially the same as what you decided to go with. A difference of 0.010" is insignificant when it comes to LEAD length. Curious; did JGS have any comments on the shoulder diameter and case body taper on your reamer spec? Were they good with the 0.08805" taper/20 inches? Good luck on your rifle project! [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
338 Lapua Improved 40 degree with print. Which design is better?
Top