Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
338 lapua brass issues
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="FindingWaldo" data-source="post: 1135009" data-attributes="member: 86355"><p>I did a reload test with 300 nosler custom competition from 86 to 92.5 gr of rotumbo. I noticed small mushrooming o primers at 92 gr and above. The limit is around 92 for this scenario. These cases still had no extraction issues. Also, used nosler brass before and it was horrible. </p><p></p><p>Also, make sure your case oal is below 2.722 anything above that was causing an increase in pressure to. Hunting guy . Com had similar experience as well. Actually I would recommend below 2.721. Hunting guy article trimmed his down to 2.714, but I think that is to much. I personally trim my to <2.721 and it's fine. Over that then I have inadquancies.</p></blockquote><p></p>
[QUOTE="FindingWaldo, post: 1135009, member: 86355"] I did a reload test with 300 nosler custom competition from 86 to 92.5 gr of rotumbo. I noticed small mushrooming o primers at 92 gr and above. The limit is around 92 for this scenario. These cases still had no extraction issues. Also, used nosler brass before and it was horrible. Also, make sure your case oal is below 2.722 anything above that was causing an increase in pressure to. Hunting guy . Com had similar experience as well. Actually I would recommend below 2.721. Hunting guy article trimmed his down to 2.714, but I think that is to much. I personally trim my to <2.721 and it's fine. Over that then I have inadquancies. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
338 lapua brass issues
Top