Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
338 edge problem
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="danj" data-source="post: 759482" data-attributes="member: 27241"><p>I've had some trouble getting some of my 338 edge loads to chamber. (The bolt will not close) The brass(Remington) is on it's third to forth load. The bullet is not touching the lands (.010 off.)The brass is trimmed to length .When I pull the load the empty brass chambers with no problem,but when I seat the bullet it will not chamber. Happens to every one out of four or five loads. Load is 300 gr SMK. Could the brass be the problem? </p><p> </p><p> Thanks Dan</p></blockquote><p></p>
[QUOTE="danj, post: 759482, member: 27241"] I've had some trouble getting some of my 338 edge loads to chamber. (The bolt will not close) The brass(Remington) is on it's third to forth load. The bullet is not touching the lands (.010 off.)The brass is trimmed to length .When I pull the load the empty brass chambers with no problem,but when I seat the bullet it will not chamber. Happens to every one out of four or five loads. Load is 300 gr SMK. Could the brass be the problem? Thanks Dan [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
338 edge problem
Top